DataCard UltraGrafix Select Instrukcja Instalacji Pobierz pdf (Strona 163)

Maxsys and MX Series Software Administrator’s Guide 151

control. A sample Card Setup screen shot is shown below. In this scenario,

emboss operation “acct” will be assigned to emboss group 1 (ganged in first and

second relative emboss modules).

• No two emboss/indent operations can specify the same emboss group.

• If an emboss/indent operation specifies a group number, that group number

must be defined in Production Options.

• If an emboss/indent operation specifies a group number, that group number

must correspond to a real module in the system.

• If an emboss/indent operation specifies a group number that pertains to a

two group module, that group must be capable of ganging that operation.

• If an emboss/indent operation specifies a group number that pertains to a

two group module, that group must include two physical modules (for

example, the group cannot designate the last module in the system as the first

module in the group).

Editing a Production Options Setup

Use the following procedure to edit a Production Options Setup.

1. In the Production Options Setup window (Applications | Setups |

Production Options Setup), highlight the setup you want to edit.

If no setups are listed, click the Open icon in the toolbar, browse to a

Productions Options Setup, and then click Open.

2. Edit the parameters as needed using the information from the previous

section.

3. Click the Save icon in the toolbar to save the new setup.

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 321 322

Brak uwag

DataCard UltraGrafix Select Instrukcja Instalacji Strona 163