DataCard LM200 Podręcznik Użytkownika Pobierz pdf (Strona 103)

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 93

Adjusting the Patch Position

Thepositionofthepatchonthecardcanvaryslightlyforeachlotoflaminatorsupplymaterial.

Youcanchangetheleft‐to‐rightpositionorthetop‐to‐bottomposition,ifneeded.

ThecurrentpatchpositioncanbeviewedontheLaminatortaboftheStatusMonitor.Referto

“LaminatorTab”onpage 47.

Changing the Front-to-Back Position

Turningthesupplysprocketofthelaminatefilmcartridgeenablesyoutoadjustthepatch

positiontothefrontorbackby1.0mm.

Usethefollowingstepstochangethefront‐to‐backpatchposition:

1. Poweroffthelaminatorandallowittocool.

2. Openthelaminatordoorandremove

thelaminatorcartridge.

3. Removethesupplyfilmfromthecartridge.

4. Pullthesprocketup(4).

5. Turnthesprocketknobtomovethe

patch(5):

 Turntheknobcounterclockwise(+)

tomovethepatchpositiontotheback.

 Turntheknobclockwise(‐)tomovethepatchpositiontothefront.

6. Releasethesprocket.

7. Loadthesupplyfilmontothecartridge.

8. Insertthecartridge,closethedoor,andpoweronthelaminator.The

laminatorinitializesthesupplymaterialautomatically.

9. Laminateacardtoverifythenewpatchposition.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 137 138

Brak uwag

DataCard LM200 Podręcznik Użytkownika Strona 103